Map Controlled Engine Cooling Thermostat -F265-, REMOVING AND INSTALLING: Removing
WARNING: This page is about a different car, the 2024 Audi S5 and 2023 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
Preliminary work may be required depending on the model. Refer to COOLANT PUMP/COOLANT THERMOSTAT .
-- Remove the connector -1- from the bracket.
-- Remove the Cylinder Block Coolant Valve -N545- -4- from the bracket and push it to the side.
-- Disconnect the connector -2- and free up the wires on the Map Controlled Engine Cooling Thermostat -F265-.
-- Remove the bolts -arrows- and remove the Map Controlled Engine Cooling Thermostat Map Controlled Engine Cooling Thermostat -F265-.
-- Dismount the seal -arrow- with the extractor lever -2-.