Engine Oil Cooler, Removing And Installing, 3.0L Engine: Removing

WARNING: This page is about a different car, the 2024 Audi S5 and 2023 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

When installing, install all heat shield boots back in the same positions.

-- Remove the turbocharger. Refer to TURBOCHARGER, REMOVING AND INSTALLING, 3.0L ENGINE .

-- Open the heat shield boot.

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connectors:

1 - For the Tank Ventilation Pressure Sensor 1 -G950-

3 - For the EVAP Canister Purge Regulator Valve 1 -N80-

-- Loosen the hose clamp -2- and disconnect the hose for the EVAP system.

-- Remove the EVAP Canister Purge Regulator Valve 1 -N80- from the bracket.

All additional procedures are described. Refer to ENGINE OIL COOLER, REMOVING AND INSTALLING .