Camshaft Adjustment Valve 1 -N205-, REMOVING AND INSTALLING

WARNING: This page is about a different car, the 2024 Audi S5 and 2023 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

The procedure applies to the Camshaft Adjustment Valve 1 -N205-, Camshaft Adjustment Valve 2 -N208-, Exhaust Camshaft Adjustment Valve 1 -N318- and Exhaust Camshaft Adjustment Valve 2 -N319-.

Removing the Camshaft Adjustment Valve 1 -N205- on 2.9L Engines with Particulate Filter:

Courtesy of AUDI OF AMERICA, LLC

-- Remove the right tower brace. Refer to TOWER BRACE, REMOVING AND INSTALLING .

-- Drain the coolant. Refer to COOLANT, DRAINING AND FILLING .

-- Lift the clamp -arrow- and remove the coolant hose.

Camshaft Adjustment Valve 1 -N205- Removing on 3.0L Engine with Coolant Recirculation Pump -V50- :

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -2-.

-- Move the retainer in direction of -arrow- and move the Coolant Recirculation Pump -V50- to the side.

Removing the Camshaft Adjustment Valve 2 -N208- on 2.9L Engines with Particulate Filter:

Courtesy of AUDI OF AMERICA, LLC

-- Remove the left tower brace. Refer to TOWER BRACE, REMOVING AND INSTALLING .

-- Release the catch in direction of -arrow- and remove the vacuum hose -1- at the same time do not damage it.

Continuation for All:

All additional procedures are described under: VALVETRAIN .

Installing

Additional procedures:

-- Install the right tower brace. Refer to TOWER BRACE, REMOVING AND INSTALLING .

-- Connect the coolant hose to the connector coupling. Refer to Fig 1.

Fig 1: Connect the Connector Coupling

Courtesy of AUDI OF AMERICA, LLC

-- Fill the coolant. Refer to COOLANT, DRAINING AND FILLING .