LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2023 >> A5 Quattro Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 349 (Cooling System (6-Cylinder Direct Fuel Injection 2.9L; 3.0L 4V TFSI Engine Ea 839) (Convertible)) >> 19 Cooling System >> Coolant Pipes >> Coolant Pipes, Removing And Installing >> Small Right Rear Coolant Pipe, Removing And Installing, 2.9L Engine >> Removing

Small Right Rear Coolant Pipe, Removing And Installing, 2.9L Engine: Removing

WARNING: This page is about a different car, the 2024 Audi S5 and 2023 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

-- Drain the coolant. Refer to COOLANT, DRAINING AND FILLING, 2.9L ENGINE .

-- Install the engine cover and heat shield. Refer to ENGINE COVER, REMOVING AND INSTALLING .

-- Vehicles without particulate filter: loosen the screw-type clamp -1- and push the catalytic converter slightly to the side.

GWWA26-11921Courtesy of AUDI OF AMERICA, LLC

-- Vehicle with particulate filter: remove the right catalytic converter. Refer to CATALYTIC CONVERTER, REMOVING AND INSTALLING, 2.9L ENGINE WITH PARTICULATE FILTER .

-- Lift the clamp -2- and remove the coolant hose.

GWWA19-12742Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -arrows- and the coolant pipe -1-.