Overview - SUBFRAME Mount

WARNING: This page is about a different car, the 2024 Audi S5 and 2023 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Engine Mount

Fig 1: Exploded View Of Engine Mount

Courtesy of AUDI OF AMERICA, LLC

Subframe
Bolt
- 20 Nm
- For the 2.9L engine
Bolt
- 10 Nm
- For the 2.9L engine
Engine Support
- Only right for the 2.9L engine
- Removing and Installing. Refer to ENGINE SUPPORT BEARING, REMOVING AND INSTALLING .
- Installation position. Refer to Fig 2.
Bolt
- 55 Nm
Engine Support
- Removing and Installing. Refer to ENGINE SUPPORT, REMOVING AND INSTALLING .
Not Installed
Not Installed
Bolt
- 55 Nm
Engine Mount
- With:
  - Left Electrohydraulic Engine Mount Solenoid Valve -N144-
  - Right Electrohydraulic Engine Mount Solenoid Valve -N145-
- Removing and Installing. Refer to ENGINE MOUNT, REMOVING AND INSTALLING .
Bolt
- 90 Nm + 90°
- Always replace after removing.
Bolt
- 30 Nm

Engine Support - Installation Position

Fig 2: Support Bearing, Installation Position

Courtesy of AUDI OF AMERICA, LLC

The raised section -2- of the engine support must engage into the opening -1- on the engine support bearing.

Transmission Mount

Fig 3: Exploded View Of Transmission Mount

Courtesy of AUDI OF AMERICA, LLC

Bolt
- Tightening specifications. Refer to the appropriate Service Information .
Tunnel Crossmember
- Removing and Installing. Refer to the appropriate Service Information .
Nut
- Tightening specifications. Refer to the appropriate Service Information .
- Only remove when the transmission mount must be separated from the transmission support
Transmission Support
- Removing and Installing. Refer to TRANSMISSION MOUNT, REMOVING AND INSTALLING .
Bolt
- Tightening specifications. Refer to the appropriate Service Information .
Transmission Mount
- Removing and Installing. Refer to TRANSMISSION MOUNT, REMOVING AND INSTALLING .
Stop
- For the transmission mount
Bolt
- Tightening specifications. Refer to the appropriate Service Information .
- Only remove when the transmission mount must be separated from the transmission support
Nut
- Tightening specifications. Refer to the appropriate Service Information .
- Only remove when the transmission mount must be separated from the transmission support