Part II
WARNING: This page is about a different car, the 2024 Audi S5, 2024 Audi RS 5, 2023 Audi S5, and 2023 Audi RS 5. However, it is still accessible from the selected car via links, so may be relevant.
Part I. Refer to Part I .
Part III. Refer to Part III .
- Nut
- 30 Nm
- After loosening, replace the stud bolt -item 4- Part II
- Tensioning Bracket
- Seal
- Replace after removing
- Stud Bolt
- 15 Nm
- After loosening, replace the nut -item 15- Part II
- Tensioning Bracket
- Nut
- 30 Nm
- After loosening, replace the stud bolt -item 4- Part II
- Oil Return Line
- Replace after removing
- Clip
- Air Duct Pipe
- Bolt
- Tightening specification -item 9- OVERVIEW - CHARGE AIR SYSTEM, 3.0L ENGINE-SIDE VERSION 1.
- Seal
- Replace after removing
- Air Duct Pipe/Connections
- There are different versions. Refer to the appropriate Electronic Parts Information for the allocation.
- Bolt
- Tightening specification -item 12- OVERVIEW - CHARGE AIR SYSTEM, 3.0L ENGINE-SIDE VERSION 1.
- Seal
- Replace after removing
- Nut
- Replace after removing
- Tightening Specifications:
- Step 1: 15 Nm
- Step 2: 30 Nm
- Step 3: After finishing the procedures, tighten the nuts to 30 Nm
- Turbocharger
- Removing and Installing. Refer to TURBOCHARGER, REMOVING AND INSTALLING, 3.0L ENGINE .
- Screw-Type Clamp
- 20 Nm
- Replace after removing
- Seal
- Replace after removing
- Coupling
- If a new turbocharger is installed, replace the coupling
- Nut
- Replace after removing
- Tightening Specifications:
- Step 1: 15 Nm
- Step 2: 30 Nm
- Step 3: After finishing the procedures, tighten the nuts to 30 Nm
- Seal
- Replace after removing
- Stud Bolt
- 15 Nm
- After loosening, replace the nut -item 20- Part II