Charge Air Pressure Sensor -G31-, REMOVING AND INSTALLING, 2.9L ENGINE
WARNING: This page is about a different car, the 2024 Audi S5, 2024 Audi RS 5, 2023 Audi S5, and 2023 Audi RS 5. However, it is still accessible from the selected car via links, so may be relevant.
Removal - Vehicles with Version 1 Charge Air System:
-- Loosen the hose clamps -1 and 3- and remove the air duct hose.
-- Disconnect the connector -1-.
-- Remove the bolt -2- and the Charge Air Pressure Sensor -G31-.
Removal - Vehicles with Version 2 Charge Air System:
-- Disconnect the connector -1-.
-- Remove the bolt -2- and the Charge Air Pressure Sensor -G31-.
Installing
Install in reverse order of removal and note the following:
- Check the O-ring for damage. Refer to OVERVIEW - CHARGE AIR SYSTEM .
Tightening Specifications
- Refer to OVERVIEW - CHARGE AIR SYSTEM
- Refer to OVERVIEW - CHARGE AIR HOSE CONNECTIONS .