Right Coolant Pipe, Removing And Installing: Removing

WARNING: This page is about a different car, the 2024 Audi S5, 2024 Audi RS 5, 2023 Audi S5, and 2023 Audi RS 5. However, it is still accessible from the selected car via links, so may be relevant.

-- Disconnect the ground cable from the battery terminal. Refer to BATTERY, DISCONNECTING AND CONNECTING .

-- Remove the noise insulation. Refer to NOISE INSULATION, REMOVING AND INSTALLING .

-- Drain the coolant. Refer to COOLANT, DRAINING AND FILLING .

-- Remove the right drive axle cover and right front wheel spoiler. Refer to OVERVIEW - FRONT WHEEL HOUSING LINER .

-- Remove the generator. Refer to GENERATOR, REMOVING AND INSTALLING .

-- Remove the bolt -arrow- and move the bracket -1- and wiring harness to the side.

Courtesy of AUDI OF AMERICA, LLC

-- Place the container of the :VAS5014 or :VAS6208 underneath.

-- Loosen the hose clamps -1 and 2- and remove the coolant hoses.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -arrows- using the :T10405 and remove the coolant pipe. (On vehicles with 3.0L engine).