Oil Spray Jets, Removing And Installing: Removing
WARNING: This page is about a different car, the 2024 Audi S5, 2024 Audi RS 5, 2023 Audi S5, and 2023 Audi RS 5. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the oil tray. Refer to OIL TRAY, REMOVING AND INSTALLING .
CAUTION:
Risk of damaging the engine by the timing mechanism skipping.
- Only let the engine turn in the direction of engine rotation.
-- Turn the crankshaft using the Wrench - 21mm:T40263 and Adapter:T40314 -arrow- until the corresponding oil spray jet is accessible.
-- Mark the installation position and the connecting rod bearing cap allocation to the cylinder and connecting rod for installing again later. Refer to Figure.
-- Remove the corresponding bolts -arrows- and remove the connecting rod bearing cap.
-- Remove the banjo bolt -2- and the oil spray jet -1-.
-- Repeat the procedure if necessary on each oil spray jet.