Overview - Cylinder Block, Transmission Side
WARNING: This page is about a different car, the 2024 Audi S5, 2024 Audi RS 5, 2023 Audi S5, and 2023 Audi RS 5. However, it is still accessible from the selected car via links, so may be relevant.
- For assembly work, secure the engine on the engine and transmission holder. Refer to ENGINE, SECURING TO ENGINE AND TRANSMISSION HOLDER .
- Bolt
- 60 Nm +90°
- Replace after removing
- Drive Plate
- With the bearing flange
- Check the contact surfaces on the bearing flange and the torque converter holes for cracks and wear grooves.
- Removing and Installing. Refer to DRIVE PLATE, REMOVING AND INSTALLING .
- Sensor Wheel
- For the Engine Speed Sensor -G28-
- Removing and Installing. Refer to SENSOR WHEEL, REMOVING AND INSTALLING .
- Check using the Vehicle Diagnostic Tester Refer to SENSOR WHEEL, CHECKING .
- Seal
- For the crankshaft on the transmission side
- Replacing. Refer to CRANKSHAFT SEAL, REPLACING, TRANSMISSION SIDE .
- Alignment Pin
- Crankshaft
- Overview. Refer to OVERVIEW - CRANKSHAFT .