Overview - SUBFRAME Mount

WARNING: This page is about a different car, the 2024 Audi S5, 2024 Audi RS 5, 2023 Audi S5, and 2023 Audi RS 5. However, it is still accessible from the selected car via links, so may be relevant.

Engine Mount

Fig 1: Exploded View Of Engine Mount

Courtesy of AUDI OF AMERICA, LLC

Subframe
Bolt
- 20 Nm
- For the 2.9L engine
Bolt
- 10 Nm
- For the 2.9L engine
Engine Support
- Only right for the 2.9L engine
- Removing and Installing. Refer to ENGINE SUPPORT BEARING, REMOVING AND INSTALLING .
- Installation position. Refer to Fig 2.
Bolt
- 55 Nm
Engine Support
- Removing and Installing. Refer to ENGINE SUPPORT, REMOVING AND INSTALLING .
Not Installed
Not Installed
Bolt
- 55 Nm
Engine Mount
- With:
  - Left Electrohydraulic Engine Mount Solenoid Valve -N144-
  - Right Electrohydraulic Engine Mount Solenoid Valve -N145-
- Removing and Installing. Refer to ENGINE MOUNT, REMOVING AND INSTALLING .
Bolt
- 90 Nm + 90°
- Always replace after removing.
Bolt
- 30 Nm

Engine Support - Installation Position

Fig 2: Support Bearing, Installation Position

Courtesy of AUDI OF AMERICA, LLC

The raised section -2- of the engine support must engage into the opening -1- on the engine support bearing.

Transmission Mount

Fig 3: Exploded View Of Transmission Mount

Courtesy of AUDI OF AMERICA, LLC

Bolt
- Tightening specifications. Refer to the appropriate Service Information .
Tunnel Crossmember
- Removing and Installing. Refer to the appropriate Service Information .
Nut
- Tightening specifications. Refer to the appropriate Service Information .
- Only remove when the transmission mount must be separated from the transmission support
Transmission Support
- Removing and Installing. Refer to TRANSMISSION MOUNT, REMOVING AND INSTALLING .
Bolt
- Tightening specifications. Refer to the appropriate Service Information .
Transmission Mount
- Removing and Installing. Refer to TRANSMISSION MOUNT, REMOVING AND INSTALLING .
Stop
- For the transmission mount
Bolt
- Tightening specifications. Refer to the appropriate Service Information .
- Only remove when the transmission mount must be separated from the transmission support
Nut
- Tightening specifications. Refer to the appropriate Service Information .
- Only remove when the transmission mount must be separated from the transmission support