Transmission Fluid Auxiliary Hydraulic Pump, Removing And Installing: Removing
WARNING: This page is about a different car, the 2024 Audi S5, 2024 Audi RS 5, 2023 Audi S5, and 2023 Audi RS 5. However, it is still accessible from the selected car via links, so may be relevant.
- The transmission is installed.
- Pay attention to the general repair information. Refer to GENERAL REPAIR INFORMATION .
- Pay attention to the guidelines for clean working conditions. Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .
-- Move the selector lever into "P".
-- Switch the ignition off.
-- Remove the transmission fluid pan. Refer to TRANSMISSION FLUID PAN, REMOVING AND INSTALLING .
-- Remove the ATF filter. Refer to TRANSMISSION FLUID SCREEN, REMOVING AND INSTALLING .
CAUTION:
Risk of destroying due to electrostatic charge.
- Do not touch the connector terminals.
- Touch a grounded object (for example the hoist) and discharge any static electricity.
-- Carefully disconnect the connector -B- for the Transmission Fluid Auxiliary Hydraulic Pump 1 -V475- -A-.
-- Remove the bolts in the sequence -3 to 1-.
-- Remove the Transmission Fluid Auxiliary Hydraulic Pump 1 -V475- -A- from the transmission housing.
- The Transmission Fluid Auxiliary Hydraulic Pump 1 -V475- fits tightly into the transmission housing because of the O-ring -D-.