Overview - MECHATRONIC, 0D7 And 0DY
WARNING: This page is about a different car, the 2024 Audi S5, 2024 Audi RS 5, 2023 Audi S5, and 2023 Audi RS 5. However, it is still accessible from the selected car via links, so may be relevant.
Coat O-rings and seals with ATF. Other types of lubrication leads to faults in the transmission control module hydraulics.
- Transmission Fluid Pan
- With integrated ATF filter
- Removing and Installing. Refer to TRANSMISSION FLUID PAN, REMOVING AND INSTALLING .
- Seal
- Replace after removing
- O-Ring
- Replace after removing
- Bolt
- Tightening specification and sequence. Refer to MECHATRONIC TIGHTENING SPECIFICATIONS .
- Replace after removing
- Bolt
- 10 Nm
- Wiring Harness
- For Transmission Fluid Auxiliary Hydraulic Pump 1 -V475-
- Removing and Installing. Refer to TRANSMISSION FLUID AUXILIARY HYDRAULIC PUMP WIRING HARNESS, REMOVING AND INSTALLING .
- O-Rings
- Replace after removing
- Lock Washer
- O-Ring
- Replace after removing
- Bolt
- 5.5 Nm
- Connector Housing
- Replace after removing
- O-Rings
- Replace after removing
- ATF Pipe
- Replace after removing
- Seals
- Replace together with the ATF line -item 13- OVERVIEW - MECHATRONIC, 0D7 AND 0DY.
- O-Ring
- Replace after removing
- Transmission Fluid Auxiliary Hydraulic Pump 1 -V475-
- Removing and Installing. Refer to TRANSMISSION FLUID AUXILIARY HYDRAULIC PUMP, REMOVING AND INSTALLING .
- Bolt
- 8 Nm
- Replace after removing
- Quantity: 3, M6x28
- Mechatronic
- Removing and Installing. Refer to MECHATRONIC, REMOVING AND INSTALLING .
- Bolt
- Tightening specification and sequence. Refer to Fig 2.
- O-Ring
- Replace after removing
- ATF Drain Plug
- Tighten all the way
Transmission Fluid Pan - Tightening Specification and Sequence (12 bolts)
-- Tighten the bolts in the steps in the sequence shown:
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1. | -1 to 12- | Install the bolts by hand until the bolt heads touch |
| 2. | -1 to 12- | 4 Nm |
| 3. | -1 to 12- | 10 Nm |