HYDRAULIC PULSE MEMORY WITH Accumulator Solenoid -N485-, REMOVING AND INSTALLING: Removing
WARNING: This page is about a different car, the 2024 Audi S5, 2024 Audi RS 5, 2023 Audi S5, and 2023 Audi RS 5. However, it is still accessible from the selected car via links, so may be relevant.
- The transmission is installed.
-- Move the transmission into the "P" position.
-- Switch the ignition off.
-- Remove the transmission fluid pan. Refer to TRANSMISSION FLUID PAN, REMOVING AND INSTALLING .
-- Remove the ATF filter. Refer to TRANSMISSION FLUID SCREEN, REMOVING AND INSTALLING .
CAUTION:
Risk of destroying due to electrostatic charge.
- Do not touch the connector terminals.
- Touch a grounded object (for example the hoist) and discharge any static electricity.
-- Disconnect the connector -B- for the hydraulic pulse memory -A- carefully.
-- Remove the bolts in the sequence -3 to 1-.
-- Remove the hydraulic pulse memory -A-.