HYDRAULIC PULSE MEMORY WITH Accumulator Solenoid -N485-, REMOVING AND INSTALLING: Installing
WARNING: This page is about a different car, the 2024 Audi S5, 2024 Audi RS 5, 2023 Audi S5, and 2023 Audi RS 5. However, it is still accessible from the selected car via links, so may be relevant.
- Replace the O-ring and bolts for the hydraulic pulse memory.
-- Install the hydraulic pulse memory -A- with a new O-ring -D-.
-- Tighten the bolt in the following sequence: -1 to 3-.
- -1- : M6x59
- -2 and 3- : M6x20
-- Connect the connector -B- and engage them.
-- Route the wire -C- according to the illustration and secure it -arrows-.
-- Install the ATF filter. Refer to TRANSMISSION FLUID SCREEN, REMOVING AND INSTALLING .
-- Install the transmission fluid pan. Refer to TRANSMISSION FLUID PAN, REMOVING AND INSTALLING .
-- Fill the ATF. Refer to ATF, DRAINING AND FILLING .