Transmission Fluid Screen, Removing And Installing: Installing

WARNING: This page is about a different car, the 2024 Audi S5, 2024 Audi RS 5, 2023 Audi S5, and 2023 Audi RS 5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying ATF Filter O-Ring On

Courtesy of AUDI

Install in reverse order of removal with note to the following:

-- Mount the O-ring -2- on the ATF filter -1-.

-- Clean both magnets -arrows-. Make sure the magnets completely contact the depressions in the ATF filter.

Fig 2: Cleaning Both Magnets Make Sure Magnets Completely Contact Depressions In ATF Filter

Courtesy of AUDI

-- Mount the ATF filter on the Mechatronic.

Fig 3: Identifying ATF Filter Correct Mounting

Courtesy of AUDI

The collar -1- on the ATF filter must be installed all the way into the opening -2- in the Mechatronic.
The mount -4- on the back must fit into the bolt -3- on the Mechatronic.

-- Install the transmission fluid pan. Refer to TRANSMISSION FLUID PAN, REMOVING AND INSTALLING .

-- Fill with ATF. Refer to ATF, DRAINING AND FILLING .