Parking Lock Shaft Seal, Replacing

Procedure

-- Remove the mechatronic. Refer to MECHATRONIC, REMOVING AND INSTALLING .

-- Remove the cable tie -arrow- from the parking lock lever -3-.

Courtesy of AUDI OF AMERICA, LLC

Tip

• The parking lock must not be latched for the following work. Turn the driveshaft to see if the parking lock is latched.
• Move the transmission output shaft with the splines so that the parking lock is not latched. Do not turn the driveshaft further.

-- Remove the spring pin -2- on the shaft for the parking lock lever using a pin punch -1-.

Fig 1: Identifying Spring Pin

Courtesy of AUDI OF AMERICA, LLC

• The tension on the return spring is reduced when the parking lock lever is removed.

-- Remove the parking lock lever -1- with the shaft in direction of -arrow-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the seal with a small screwdriver.

-- Apply ATF to the outer edge and the space between the sealing lips of the new seal.

• Installation position: open side of the seal faces the transmission.

-- Mount the gasket on the transmission housing and push it in all the way using a suitable socket in direction of -arrow-.

Fig 2: Mount Shaft Seal On Transmission Housing And Push It In All Way Using A Suitable Socket

Courtesy of AUDI OF AMERICA, LLC

-- Insert the parking lock lever and shaft and at the same time, attach the return spring to the stop lever and to the transmission housing -arrows-.

Fig 3: Identifying Return Spring

Courtesy of AUDI OF AMERICA, LLC

Tip

• If the actuator rod for the locking latch moves too far to the rear, then it can be pulled forward in direction of -arrow 1- while pushing the locking latch at the same time in direction of -arrow 2-.
  Fig 4: Actuator Rod For Locking Latch Moves Too Far To Rear

  Courtesy of AUDI OF AMERICA, LLC

-- Drive in the tensioning pin -2- on the parking lock lever shaft using a pin punch -1- in direction of -arrow-, at the same time pay attention to the installation position. Refer to Fig 5.

Fig 5: Spring Pin Installation Position

Courtesy of AUDI OF AMERICA, LLC

Fig 6: Identifying Spring Pin

Courtesy of AUDI OF AMERICA, LLC

-- Install the Mechatronic. Refer to MECHATRONIC, REMOVING AND INSTALLING .

-- Fill the ATF. Refer to ATF LEVEL, CHECKING .

-- Check the parking lock emergency release. Refer to EMERGENCY RELEASE FROM P .