ATF, Filling
WARNING: This page is about a different car, the 2024 Audi S5, 2024 Audi RS 5, 2023 Audi S5, and 2023 Audi RS 5. However, it is still accessible from the selected car via links, so may be relevant.
- If no ATF leaks out of the ATF check and fill hole -arrow B- before the ATF reaches 40 °C (104 °F):
- At 45 °C (113 °F) the ATF inspection plug must be installed again. Let the transmission cool down and check again.
-- Install the :VAS6262/5 into the ATF check and fill hole -arrow-.
-- Fill the ATF using the adapter until the ATF starts to leak out of the check and fill hole.
-- Tighten the new plug -arrow B-. The ATF level test is now completed.
Tightening Specifications
- Drain and plug. Refer to COMPONENT LOCATION OVERVIEW - DRAIN AND CHECK PLUGS .
- Refer to OVERVIEW - NOISE INSULATION .