Ribbed Belt, Removing And Installing, Vehicle With Starter Generator: Installing

Install in the reverse order of removal while noting the following:

-- Install the ribbed belt. Refer to Figure.

• If the ribbed belt tensioner is not locked the assembly condition must be created first. Refer to If there is no ribbed belt installed (torn, for example) .

-- Turn the tensioning system slightly in the -direction of the arrow- and remove the Locking Pin:T10060 A  .

-- Release the tension on the tensioner.

-- Check whether the ribbed belt is routed correctly.

-- Start the engine and check whether the ribbed belt runs correctly.