Overview - Bumper Cover, S Line, Sq5 Before Product Improvement

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exploded View Of Bumper Cover (S Line Before Product Improvement, SQ5)

Courtesy of AUDI

Bolt
- Quantity: 4
- 5 Nm
Bolt
- Quantity: 2
- 2 Nm
End Panel
- The bumper cover
- Removing and Installing. Refer to BUMPER COVER END PLATE, REMOVING AND INSTALLING, BEFORE PRODUCT IMPROVEMENT .
Trim Molding
- Equipped on some models
- Removing and Installing. Refer to TRIM MOLDING FOR BUMPER COVER LOWER SECTION, REMOVING AND INSTALLING .
Bumper Cover Lower Section
- Removing and Installing. Refer to BUMPER COVER LOWER SECTION, REMOVING AND INSTALLING .
Connecting Piece
- For the bumper cover side panel
- Removing and Installing. Refer to CONNECTING PIECE FOR BUMPER COVER SIDE PANEL, REMOVING AND INSTALLING .
Radiator Grille
- Overview. Refer to OVERVIEW - RADIATOR GRILLE .
Air Intake Grille
- Center
- Removing and Installing. Refer to CENTER AIR INTAKE GRILLE, REMOVING AND INSTALLING, BEFORE PRODUCT IMPROVEMENT .
Lock Carrier Cover
- Removing and Installing. Refer to LOCK CARRIER COVER, REMOVING AND INSTALLING .
Bolt
- Quantity: 7
- 2 Nm
Bolt
- Quantity: 2
- 2 Nm
End Panel
- For the bumper cover side panel
- Removing and Installing. Refer to BUMPER COVER SIDE PANEL END PLATE, REMOVING AND INSTALLING, BEFORE PRODUCT IMPROVEMENT .
Securing Strip
- For the bumper cover side panel
- Removing and Installing. Refer to SECURING STRIP FOR BUMPER COVER SIDE PANEL, REMOVING AND INSTALLING .
Mount
- For the bumper cover
- Removing and Installing. Refer to BUMPER COVER MOUNT, REMOVING AND INSTALLING .
Bolt
- 2 Nm
Expanding Rivet
Bolt
- Quantity: 2
- 2 Nm
Bumper Cover Side Panel
- Removing and Installing. Refer to BUMPER COVER SIDE PANEL, REMOVING AND INSTALLING .
- Bumper Cover, Removing and Installing. Refer to BUMPER COVER, REMOVING AND INSTALLING .
Cover
Equipment versions with headlamp washer system
- Washer Nozzle Cover, Removing and Installing. Refer to HEADLAMP WASHER SYSTEM WASHER NOZZLE COVER, REMOVING AND INSTALLING
  Equipment versions without headlamp washer system
- Blind cover, removing and installing. Refer to BLIND COVER IN BUMPER COVER, REMOVING AND INSTALLING .
Bolt
- 2 Nm
Clip
- Quantity: 2
Cap
- For the air intake grille
- Equipped on some models
Mount
- For the parking aid sensor
- Removing and Installing. Refer to FRONT PARKING AID SENSOR, REMOVING AND INSTALLING .
Air Intake Grille
- Side
- Removing and Installing. Refer to SIDE AIR INTAKE GRILLE, REMOVING AND INSTALLING .