OVERVIEW - STEERING COLUMN, MANUAL WITH Active Steering Motor -V477-
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 20 Nm +90°
- Replace after removing
- Clean the threaded hole, for example, using a thread tap, before installing the new bolt.
- Install the bolt first by hand in the first threads. Check if the steering intermediate shaft is seated correctly by pulling. Then tighten the bolt.
- Steering Intermediate Shaft
- Removing and installing. Refer to STEERING INTERMEDIATE SHAFT, REMOVING AND INSTALLING .
- RHD: is a mirror image
- Instrument Panel Central Tube
- Bolt
- 4.5 Nm
- Electronic Steering Column Lock Control Module -J764-
- Removing and installing. Refer to Electronic Steering Column Lock Control Module -J764-, REMOVING AND INSTALLING .
- RHD: is a mirror image
- Steering Column
- There are different versions. Refer to the appropriate Electronic Parts Information for the allocation.
- Removing and installing. Refer to STEERING COLUMN, REMOVING AND INSTALLING .
- Check for damage. Refer to STEERING COLUMN, CHECKING FOR DAMAGE .
- RHD: is a mirror image
- Anti-Theft Protection Component Lower Section
- Equipment version with manual transmission
- Bolt
- Tightening specification and sequence. Refer to Figure.
- Quantity: 4
- Anti-Theft Protection Component Upper Section
- Equipment version with manual transmission
- Handle
- For the steering column adjustment
- RHD: is a mirror image
- Bolt
- 5 Nm
- Active Steering Motor -V477-
- Steering column component
- Do not disconnect or loosen from the steering column
- If the Active Steering Motor -V477- is faulty, replace the steering column. Refer to STEERING COLUMN, REMOVING AND INSTALLING .
- RHD: is a mirror image
- Active Steering Safety Lock Actuator -F437-
- Removing and installing. Refer to ACTIVE STEERING SAFETY LOCK (LOCKING SOLENOID), REMOVING AND INSTALLING .
- Bolt
- Tightening specification and sequence. Refer to Fig 2.
- Damper
- Steering column component
- Pin
- Steering column component
- Do not disconnect or loosen from the steering column
- Bolt
- 20 Nm +90°
- Replace after removing
- Clean the threaded hole (for example, using a thread tap) before installing the new bolt.
- Install the bolt first by hand in the first threads. Check the if the steering intermediate shaft is seated correctly by pulling. Then tighten the bolt.
- Nut
- 4.5 Nm
Active Steering Safety Lock (Locking Solenoid) - Tightening Specification and Sequence
-- Tighten the bolts in steps:
| Step | Bolt | Tightening Specification |
|---|---|---|
| 1. | -1- | 2 + 2 Nm |
| 2. | -2- | 4 + 2 Nm |
| 3. | -1- | 8 + 2 Nm |
| 4. | -2- | 8 + 2 Nm |