Pedestrian Protection Trigger 1 -G598- / PEDESTRIAN PROTECTION TRIGGER 2 Pedestrian Protection Trigger 2 -G599-, REMOVING AND INSTALLING: Removing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Risk of injury due to involuntary deployment.
- Pay attention to the safety precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS WHEN WORKING WITH PYROTECHNIC COMPONENTS .
-- Disconnect the battery ground cable when the ignition is turned on. Refer to BATTERY, DISCONNECTING AND CONNECTING .
-- Remove the fender cover. Refer to OVERVIEW - FENDER .
WARNING:
Risk of injury due to involuntary deployment.
- Before handling pyrotechnic components (for example, disconnecting the connector), the person handling it must "discharge static electricity". For example, this can be done by briefly touching the door striker.
-- Press the release to free up and disconnect the pedestrian protection trigger connector.
-- Remove the clip -1- with a screwdriver.
-- Release the clip -3- by pulling on the clip -arrow A- and pushing it in the -direction of arrow B- over the pin -4- at the same time.
-- Press the securing clip -5- -arrow C- and hold it pressed and at the same time remove the trigger for the pedestrian protection -2- from the pin.