Front Belt End Fitting, Removing And Installing: Removing
WARNING: This page is about a different car, the 2023 Audi SQ8, 2023 Audi RS Q8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the front sill panel. Refer to FRONT SILL PANEL, REMOVING AND INSTALLING .
-- Remove the belt end fitting from the bracket.
-- Open the cover -2- for the belt anchor -1- with a screwdriver on the catches -arrow-, open and push aside.
-- Push together the catches on the clamp with a plies in direction of -A arrows-.
-- At the same time push the anchoring pins -2- together with the clamp -3- to release in the direction of -arrow B-.
-- Disengage the anchoring pins from the clamp in the belt end fitting -1-.
-- Remove the bolt -1- and then remove the belt relay -2-.