Component Location Overview - 48V System Wire Junction
WARNING: This page is about a different car, the 2024 Audi SQ8, 2024 Audi Q8, 2023 Audi SQ8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.
- Mount
- For Suppressor -C24-
- Removing and installing. Refer to Suppressor -C24-, REMOVING AND INSTALLING, 48V SYSTEM .
- Suppressor -C24-
- Removing and installing. Refer to Suppressor -C24-, REMOVING AND INSTALLING, 48V SYSTEM .
- Cap
- Positive Cable
- To starter, generator
- Nut
- 16 Nm
- Positive Cable
- From the Battery -A-
- Nut
- 20 Nm
- Terminal 30a Wire Junction -TV3-
- Component Location Overview. Refer to Component Location Overview - Terminal 30 Wire Junction -TV2- and Terminal 30a Wire Junction -TV3- .
- Nut
- Tightening specification COMPONENT LOCATION OVERVIEW - RELAY PANEL, INSTRUMENT PANEL, E-BOXES ENGINE COMPARTMENT.
- Wire
- To the Suspension Stabilization Control Module 1 -J1152-
- Nut
- 20 Nm
- Wire
- Nut
- 9 Nm
- Terminal 40 Wire Junction -TV66-
- Removing and installing. Refer to Terminal 40 Wire Junction -TV66-, REMOVING AND INSTALLING .
- Bolt
- Quantity: 2
- 3 Nm
- Nut
- Quantity: 3
- 3 Nm
- Terminal 30 Wire Junction -TV2-
- Removing and installing. Refer to Terminal 30 Wire Junction -TV2-, REMOVING AND INSTALLING, VEHICLES WITH 48V SYSTEM .