Seat Depth Adjuster, Removing And Installing: Removing

WARNING: This page is about a different car, the 2024 Audi SQ8, 2024 Audi Q8, 2023 Audi SQ8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.

-- Move seat depth adjuster forward.

-- Remove the front seat. Refer to FRONT SEAT, REMOVING AND INSTALLING .

-- Secure the front seat to the Engine/Transmission Holder - Seat Repair Fixture:VAS 6136 . Refer to FRONT SEAT, MOUNTING ON FIXTURE FOR SEAT REPAIR .

-- Remove the seat frame trim panel/control module/compressor bracket. Refer to.Refer to SEAT FRAME TRIM PANEL/CONTROL MODULE/COMPRESSOR BRACKET, REMOVING AND INSTALLING

-- Disengage the left and right rubber bands -2- at the seat depth adjuster and secure from sliding back using a cable tie, for example.

Courtesy of AUDI

-- Disengage the molding -1- for the cover on the seat depth adjuster.

-- Release and disconnect the connector -1-.

Courtesy of AUDI

-- Free up the wiring harness.

-- Remove the bolts -2 to 5-.

-- Release the tabs -2 and 3- and remove the seat cushion retaining plate together with the cover and seat cushion.

Courtesy of AUDI

-- Push the cover and seat cushion back or lift up.

-- Disengage and remove the seat depth adjuster from the attachments -1 and 4-.