Cover, Removing And Installing: Installing
WARNING: This page is about a different car, the 2024 Audi SQ8, 2024 Audi Q8, 2023 Audi SQ8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
- The vehicle and the cover must be at room temperature.
- The adhesive surfaces must be free of dirt and grease.
-- Remove the adhesive residue from the body.
-- Clean the painted side of the adhesive surface with Cleaning Solution and let it dry.
-- Remove the protective film from the adhesive tape -2, 3 and 4-.
-- Engage the door cover -1- on the bottom of the door -6- and align via the locating pin -5-.
-- Press the door cover clips -1- on until they click into place -arrows-.
-- Press on the door cover in the adhesive surface area with the Roller: T40400 .
- Resting time approximately 30 minutes at room temperature