LEFT SEAL, REPLACING, 0D3 "quattro sport" AND 0BX "quattro sport": Removing
WARNING: This page is about a different car, the 2023 Audi SQ8, 2023 Audi RS Q8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.
- Follow all general repair information. Refer to REPAIR INFORMATION .
-- Remove the rear final drive. Refer to FINAL DRIVE, REMOVING AND INSTALLING .
-- Remove the flange shaft bolt. To do this, install two bolts into the flange and counterhold the flange shaft using an assembly lever.
-- Remove the flange shaft.
Tip:
- If it is not possible to remove the flange shaft by hand, then use the Slide Hammer Set VW 771 to remove it.
-- Remove flange shaft seal with the Slide Hammer Set :VW 771 and Slide Hammer Set - Pulling Hook :VW 771/37 .