GEAR OIL LEVEL, CHECKING, 0D3 "quattro sport" AND 0BX "quattro sport"
WARNING: This page is about a different car, the 2023 Audi SQ8, 2023 Audi RS Q8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.
Test requirement
- Gear oil temperature: 10 °C to 60 °C (50 °F to 140 °F)
- The rear final drive must be in the installed position.
- The vehicle must be level.
- Refer to COMPONENT LOCATION OVERVIEW - DRAIN AND CHECK PLUGS, 0D3 "quattro sport" AND 0BX "quattro sport"
Special tools and workshop equipment required
- Drip Tray
-- Remove the gear oil check plug -1-, located on the right side of the final drive.
- The oil level is correct when the rear final drive is filled up to the lower edge of the oil fill hole.
- Refer to the appropriate Electronic Parts Information for the correct transmission fluid specification.
-- If necessary, fill the gear oil.
- Refer to GEAR OIL, DRAINING AND FILLING
-- Install and tighten the gear oil check plug -1-. Tightening specification COMPONENT LOCATION OVERVIEW - DRAIN AND CHECK PLUGS, 0D3 "quattro sport" AND 0BX "quattro sport".