All-Wheel Drive Pump -V415-, REMOVING AND INSTALLING, 0D3 AND 0BX: Notes
WARNING: This page is about a different car, the 2023 Audi SQ8, 2023 Audi RS Q8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Hex Ball Socket:T10058
- Pay attention to the general repair information. Refer to REPAIR INFORMATION .
- Pay attention to the safety precautions. Refer to SAFETY PRECAUTIONS .
Removing
-- Place the vehicle on a hoist.
- The ignition is off.
-- Place the Drip Tray under the rear final drive.
-- Disconnect the connector -1- from the All-Wheel Drive Pump -V415- -2-.
-- Remove the four bolts that connect the All-Wheel Drive Pump -V415- to the hydraulic control unit using the Hex Ball Socket:T10058 .
-- Carefully remove the All-Wheel Drive Pump -V415- -2-. Pay attention to the adapter OVERVIEW - HYDRAULIC CONTROL UNIT 0D3 AND 0BX in the hydraulic pump while doing so.
- The adapter could fall out when removing the All-Wheel Drive Pump -V415-.
- Insert the adapter into the recesses in the hydraulic pump before installing the All-Wheel Drive Pump -V415-.