Oil Separator, Removing And Installing: Removing

WARNING: This page is about a different car, the 2024 Audi Q7 and 2023 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the cylinder ignition coils "3 and 4". Refer to IGNITION COIL, REMOVING AND INSTALLING .

-- Remove the bolts -arrows- and move the engine lifting eye -1- to the side.

Courtesy of AUDI OF AMERICA, LLC

-- If installed, disconnect the connector -1- for the Tank Ventilation Pressure Sensor 1 -G950-.

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the hose clamp -1- and remove the hose from the EVAP Canister Purge Regulator Valve 1 -N80-.

Courtesy of AUDI OF AMERICA, LLC

-- Press the release buttons on both sides and remove the crankcase ventilation hose -2-.

-- Remove the bolts -arrows- and the oil separator.