Fuel Tank Pressure Sensor -G400-, REMOVING AND INSTALLING, AUDI Q7: Removing

WARNING: This page is about a different car, the 2024 Audi SQ7, 2024 Audi Q7, 2023 Audi SQ7, and 2023 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

-- Observe the safety instructions. Refer to SAFETY PRECAUTIONS .

-- Follow the guidelines for clean working conditions. Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .

-- Remove the right rear wheel housing liner. Refer to REAR WHEEL HOUSING LINER, REMOVING AND INSTALLING .

-- Release and disconnect the connector -arrow-.

Courtesy of AUDI

-- Remove the vent hose -1- by loosening the hose clamp.

-- Remove the bolts -2 and 3-.

-- Remove the bracket -4- with the Fuel Tank Pressure Sensor -G400- and air filter.

-- Remove the vent hose -2- by loosening the hose clamp.

Courtesy of AUDI

-- Remove the bolts -3-.

-- Remove the Fuel Tank Pressure Sensor -G400- -item 4- from the bracket.

Air Filter, Removing:

-- Remove the vent hose -2- by loosening the hose clamp.

-- Remove the bolt -arrow-.

-- Remove leak detection system air filter -1-.