Right Rear Coolant Pipes On Longitudinal Member, Removing And Installing: Removing

WARNING: This page is about a different car, the 2024 Audi SQ7 and 2023 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .

-- If installed, remove the driving dynamic support. Refer to DRIVING DYNAMIC SUPPORT, REMOVING AND INSTALLING .

-- Place a cloth underneath to catch any escaping coolant.

Fig 1: Coolant Pipes on Longitudinal Member

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the coolant hoses from the corresponding coolant pipes -1 or 2- with the Hose Clamps - Up To 25 mm :3094 .

-- Loosen the hose clamps -arrows- and remove the coolant hoses from the coolant pipe.

-- Remove the nuts -3- and remove the coolant pipe -1 or 2-.