Map Controlled Engine Cooling Thermostat -F265-, REMOVING AND INSTALLING: Installing
WARNING: This page is about a different car, the 2024 Audi SQ7 and 2023 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
- Replace the gasket and o-ring after removal.
-- Push the seal -1- on the Thrust Piece:T40425 -arrows-.
- The open side of seal faces upward.
-- Install the seal with the Thrust Piece:T40425 -item 1- to do so turn the bolts -arrows- all around correspondingly one half a turn all the way.
-- Check if the Thrust Piece is positioned all around on the cylinder block. If necessary, drive in with light hammering.
Additional procedures depending on the model. Refer to COOLANT PUMP/COOLANT THERMOSTAT .