Right Center Vent Motor -V111-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2024 Audi SQ7, 2024 Audi Q7, 2023 Audi SQ7, and 2023 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Vehicles with High-Voltage System

-- Switch off (deactivate) the "parking air conditioner". Refer to Owner's Manual.

Continuation for all vehicles

-- Switch off the ignition.

-- Move the right front seat all the way to the rear.

LHD vehicle

-- If equipped, remove the air duct for the glove compartment cooling. Refer to AIR GUIDE FOR GLOVE COMPARTMENT COOLING, REMOVING AND INSTALLING .

-- Remove the footwell vent on the front passenger side. Refer to FRONT PASSENGER SIDE FOOTWELL VENT, REMOVING AND INSTALLING .

-- Loosen the air duct over the instrument panel crossmember and push as far as possible to the outer side.

RHD vehicles

-- Remove the instrument panel. Refer to INSTRUMENT PANEL, REMOVING AND INSTALLING .

Continuation for all vehicles

Courtesy of AUDI OF AMERICA, LLC

-- Label the connector -A- and the actuator -C- (to avoid a mix up in case several connectors are disconnected at the same time).

-- Remove the bolts -B-. If necessary, remove the right instrument panel vent air duct from the heater and A/C unit and push slightly to the side.

-- Remove the actuator -C- from the shaft -D- for operating the doors.

-- Release and disconnect the connector -A-.