Left Rear Upper Body Vent Adjustment Motor -V315-, REMOVING AND INSTALLING: Installing

WARNING: This page is about a different car, the 2024 Audi SQ7, 2024 Audi Q7, 2023 Audi SQ7, and 2023 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Connector -A- And Adjustment Motor -C-

Courtesy of AUDI OF AMERICA, LLC

Install in the reverse order of removal while noting the following:

CAUTION:

There is a risk of damaging the adjustment motor electronics when turning the mount.

- Turn the adjustment motor mount only when the wiring harness is connected.

- Install the mount carefully and slowly by hand.

The actuator mount does not have a stop. It turns constantly if the actuator is activated. Therefore, it should not be activated when the actuator is removed.
Check the connection between the actuator mount and the shaft; there must not be any play.
The actuator -E- mount can only be installed in one position on the relay lever -D-.

-- Check the relay lever -D- and the mount of actuator -E-. They must be properly aligned so that they can be joined.

TIP

If the actuator mount -E- is not in the illustrated position (the connecting piece can only be installed in this position), install the connector -A- on the actuator -C- and turn the actuator mount -E- carefully to the position in which the two parts can be joined without pretension.

-- Ensure that the fastener -D- is in the correct installation position.

-- Install the actuator mount -E- onto the connecting element -D-.

-- Check the connection between the actuator -E- and the fastener -D-. There must be no play.

-- Install the bolts -B-.

-- Connect the connector -A-.

-- Install wiring harness -F- so that it cannot come in contact with any moving parts.

-- Perform a basic setting for the A/C system. Refer to GENERAL INFORMATION AND PROCEDURES FOR REMOVING AND INSTALLING ADJUSTMENT MOTORS .