Trailer Hitch Socket, Removing And Installing - Version 2: Removing

WARNING: This page is about a different car, the 2024 Audi SQ7, 2024 Audi Q7, 2023 Audi SQ7, and 2023 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Cable Tie -1-, Screws -2- & -4- And Trailer Hitch -3-

Courtesy of AUDI

NOTE:

During installation, install the cable ties at the same location.

-- Turn off the ignition and remove the key.

-- Unfold and engage the trailer hitch.

-- Cut the cable tie -1- and remove the screws -2 and 4-.

-- Press the socket out of trailer hitch -3- in direction of -arrow-.

-- Turn cap -1- counterclockwise -arrow- and remove it from socket -3-.

Fig 2: Turning Cap -1- Counterclockwise -Arrow- To Remove It From Socket -3-

Courtesy of AUDI

-- Remove rubber cover -2-.

-- Release the retaining clips in the direction of -arrows- and press multiple connector -2- out of socket -1-.

Fig 3: Releasing Retaining Clips -Arrows- To Press Multiple Connector -2- Out Of Socket -1-

Courtesy of AUDI

-- Release the retaining clips in the direction of -arrows- and remove retainer -1- from multiple connector -3-.

Fig 4: Releasing Retaining Clips -Arrows- To Remove Retainer -1- From Multiple Connector -3-

Courtesy of AUDI

NOTE:

Carefully remove the retainer so that contacts -2- of the multiple connector are not disconnected from the wiring harness.