FLANGE SHAFT PROTECTIVE RING, REPLACING, 0B0 AND 09R "quattro ultra"

WARNING: This page is about a different car, the 2024 Audi SQ7, 2024 Audi Q7, 2023 Audi SQ7, and 2023 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Press Plate:VW 401

Fig 1: Press Plate
Courtesy of AUDI
Press Plate:VW 402

Fig 2: Press Plate VW402
Courtesy of AUDI
Press Piece - Multiple Use:VW 412

Fig 3: Identifying Press Piece - Multiple Use VW412
Courtesy of AUDI
-3- Separating Tool - 22 to 115mm, for example Splitter:VAS251411

Fig 4: Commercially Available Puller Set
Courtesy of AUDI
Seal Installer - Drive Flange:T10143

Courtesy of AUDI
Seal Installer - Clutch Housing:T40260

Courtesy of AUDI

Flange shaft removed.

Removing the protective ring A from the flange shaft

Fig 5: Identifying Separating Tool

Courtesy of AUDI

B -

Separating Tool, for example, Splitter:VAS251411

Installing the protective ring 1 on the flange shaft

Fig 6: Installing the protective ring -1- on the flange shaft

Courtesy of AUDI

Installation position: the larger outer diameter of the protective ring faces toward the flange.
This image is a symbolic illustration. Use the Seal Installer - Drive Flange:T10143 .
On the final drive "09R" use the Seal Installer - Clutch Housing:T40260 for the left flange shaft.