LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2022 >> SQ8 Premium Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 119 (Crankshaft, Cylinder Block (4-Cylinder Direct Injection 2.0L 4V TFSI Engine (Ea 888EVO4)) (DPVA)) >> 13 Crankshaft, Cylinder Block >> Cylinder Block, Belt Pulley Side >> Ribbed Belt, Removing And Installing >> Ribbed Belt, Removing And Installing, Vehicle With Generator >> Installing

Ribbed Belt, Removing And Installing, Vehicle With Generator: Installing

WARNING: This page is about a different car, the 2024 Audi Q5 and 2023 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

-- Install the ribbed belt. Refer to Figure.

-- Turn the tensioner slightly clockwise -arrow- and remove the Locking Pin:T10060A  .

-- Release the tension on the tensioner.

-- Check whether the ribbed belt is routed correctly.

-- Start the engine and check whether the ribbed belt runs correctly.

scientia non olet · About LEMON Manuals