Turbocharger, Removing And Installing, Cylinder Bank 1 (Right): Removing

-- Remove the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .

-- Remove the reinforcement brace. Refer to OVERVIEW - LOCK CARRIER .

-- Drain the coolant. Refer to COOLANT, DRAINING AND FILLING .

-- Remove the ribbed belt tensioner for the A/C compressor. Refer to RIBBED BELT TENSIONER, REMOVING AND INSTALLING .

-- Loosen the hose clamp -1- and remove the coolant hose.

Courtesy of AUDI

-- Remove the connector -arrow- for the Oxygen Sensor 1 Before Catalytic Converter -GX10- from the bracket, disconnect it and free up the wire.

Courtesy of AUDI

All additional procedures are described under: TURBOCHARGER, REMOVING AND INSTALLING .