Drive Plate, Removing And Installing: Removing
WARNING: This page is about a different car, the 2024 Audi A8 Quattro, 2023 Audi A8 Quattro, and 2022 Audi A8 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- The transmission is removed. Refer to TRANSMISSION, REMOVING .
-- Insert the Counterhold - Flywheel: 10 - 201 to loosen the bolts.
CAUTION:
Risk of damaging the outer surface of the bearing flange at the drive plate if handled incorrectly.
- To loosen and tighten the drive plate bolt use the following tools.
-- Use an internal multi-point socket with a shaft that is at least 40 mm long to loosen and tighten the drive plate bolts.
-- Remove the bolts, drive plate -1- and sensor wheel.