Vibration Damper, Removing And Installing: Installing

WARNING: This page is about a different car, the 2024 Audi A8 Quattro, 2023 Audi A8 Quattro, and 2022 Audi A8 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

Risk of destroying the engine with the friction disc not being installed.

- Check the installation of the friction disc (diamond disc) between the vibration damper and the camshaft stub.

Replace bolts that were tightened with an additional turn after removing them.

-- Place the vibration damper -1- with a friction disk (diamond disc) -2- on the crankshaft -3- and secure with a new bolt while paying attention to the alignment pin -arrow-.

-- Place the Adapter : T40330/5 with Counterholder : T40330/1 on the vibration damper and secure using the M8x35 bolt -arrow- (23 Nm) by placing the Spacer Sleeve : T40330/3 underneath.

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the vibration damper bolt -1-.

-- Remove the bolt -arrow- and remove the counterholder.

-- Install the Starter generator ribbed belt. Refer to RIBBED BELT, REMOVING AND INSTALLING .

There are different procedures depending on the model. Refer to VIBRATION DAMPER, REMOVING AND INSTALLING .