Overview - Coolant Pump/Coolant Thermostat
WARNING: This page is about a different car, the 2024 Audi A8 Quattro, 2023 Audi A8 Quattro, and 2022 Audi A8 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Shown on a 3.0L engine.
- Coolant Shut-Off Valve
- Removing and Installing. Refer to COOLANT VALVES, REMOVING AND INSTALLING .
- Bolt
- 9 Nm
- Map Controlled Engine Cooling Thermostat -F265-
- Removing and Installing. Refer to Map Controlled Engine Cooling Thermostat -F265-, REMOVING AND INSTALLING .
- Bolt
- 10 Nm +90°
- Replace after removing
- Belt Pulley
- For the coolant pump
- Coolant Pump
- Removing and Installing. Refer to COOLANT PUMP, REMOVING AND INSTALLING .
- Bolt
- Tightening Specifications and Sequence. Refer to Fig 2.
- Seal
- Replace after removing
- Seal
- Replace the Map Controlled Engine Cooling Thermostat Map Controlled Engine Cooling Thermostat -F265- after removing
- O-Ring
- Replace after removing
- O-Ring
- Replace after removing
- Seal
- Replace after removing
- Bolt
- 9 Nm
Coolant Pump - Tightening Specifications and Sequence
-- Tighten the bolts in the steps in the sequence shown:
| Step | Bolts | Tightening Specification |
|---|---|---|
| 1. | -1 and 2- | 9 Nm |
| 2. | -1 to 7- | 9 Nm |