Crankshaft, Removing And Installing: Installing
WARNING: This page is about a different car, the 2024 Audi A8 Quattro, 2023 Audi A8 Quattro, and 2022 Audi A8 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
- Replace bolts that were tightened with an additional turn after removing them.
- Lock the gear backlash with the Adjusting Pin: T40362 .
-- Note the allocation:
- Bearing Cap. Refer to Figure.
- Bearing Shells. Refer to MAIN BEARING SHELLS ALLOCATION .
-- Coat the contact surface of the bearing shells with engine oil.
-- Move the crankshaft into the installation position and slide on and at the same time pay attention to the markings:
- The mark -A- from the crankshaft -1- must be positioned between both marks -B- from the gear -2- for the balance shaft.