Valve Guides, Checking

Special tools and workshop equipment required 

• Dial Indicator Holder: VW387 
  Fig 1: Dial Gauge Holder

  Courtesy of AUDI OF AMERICA, LLC
• Dial Indicator - 0-10mm: VAS 6079 
  Fig 2: Dial Gauge

  Courtesy of AUDI OF AMERICA, LLC

Procedure 

• If the valve is replaced during a repair, use a new valve for measurement.
• Only use an intake valve in the intake valve guide and an exhaust valve in the exhaust valve guide.

-- Secure the Dial Gauge - 0-10mm: VAS 6079  on the cylinder head with the Dial Gauge Holder: VW 387  as shown.

Fig 3: Identifying Dial Gauge With Holder

Courtesy of AUDI OF AMERICA, LLC

-- Place the valve in the valve guide.

• Valve stem tip must seal with the valve guide.

-- Determine the tilting clearance.

• Wear limit: 0.8 mm

-- If the wear limit is exceeded, measure using new valves.

-- Replace the cylinder head if the wear limit is still exceeded. (The valve guides cannot be replaced.)