Flange/Driveshaft Protective Ring, Replacing

Special tools and workshop equipment required 

• Press Plate: VW 401 
  Fig 1: Press Plate

  Courtesy of AUDI OF AMERICA, LLC
• Press Piece - Rod: VW 407 

  Courtesy of AUDI OF AMERICA, LLC

• Press Piece - Multiple Use: VW 412 
  Fig 2: Identifying Press Piece - Multiple Use VW412

  Courtesy of AUDI OF AMERICA, LLC
• Seal Installer - Flange Shaft: T10049 

  Courtesy of AUDI OF AMERICA, LLC

• -3- 22 to 75 mm Separating Tool, for example Splitter: VAS251411 
  Fig 3: Commercially Available Puller Set

  Courtesy of AUDI OF AMERICA, LLC

• Flange/driveshaft removed.

Press the protective ring off the flange/driveshaft.

Fig 4: Pressing Dust Cap Off Of Driveshaft Flange

Courtesy of AUDI OF AMERICA, LLC

A -

22 to 115 mm Separating Tool, for example Splitter: VAS251411 

Install the protective ring arrow onto the flange/driveshaft.

Fig 5: Install the protective ring -arrow- onto the flange/driveshaft.

Courtesy of AUDI OF AMERICA, LLC

• Installation position: ribbed side of the protective ring points to the flange.
• The protective ring -A- must engage audibly in the groove on the flange.