Trailer Hitch Socket, Removing And Installing - Version 3: Removing

WARNING: This page is about a different car, the 2022 Audi SQ7 and 2022 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Trailer Hitch Wiring Socket Components

Courtesy of AUDI OF AMERICA, LLC

-- Fold out the trailer hitch. Refer to the vehicle Owner's Manual.

-- Switch off the ignition and remove the ignition key.

-- Remove the bolts -arrows-.

-- Remove the socket from the retaining plate.

-- Remove the rubber cover from the socket.

-- Release the clips in the direction of -arrows- and push the multi-pin connector -1- out of the socket -2-.

Fig 2: Releasing Retaining Clips -Arrows- To Press Multiple Connector -1- Out Of Socket -1-

Courtesy of AUDI OF AMERICA, LLC

-- Release the retaining clips in direction of -arrows- and remove retainer -2- from multiple connector -3-.

Fig 3: Releasing Retaining Clips -Arrows- To Remove Retainer -2- From Multiple Connector -3-

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Carefully remove the retainer so that contacts -2- of the multiple connector are not disconnected from the wiring harness.