Windshield Wiper Arms, Removing And Installing, Windshield Wipers With Integrated Washer Nozzles: Removing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ7, 2022 Audi Q7, 2021 Audi SQ7, 2021 Audi Q7, and 2020 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the service cover -1- on the plenum chamber cover in direction of -arrow-.

Courtesy of AUDI OF AMERICA, LLC

-- Free up the washer fluid hoses.

-- Disconnect the connector -6-.

Courtesy of AUDI OF AMERICA, LLC

-- Release the retainers and disconnect the washer fluid hoses -4 and 5- at the connection points.

-- Free up the grommet -2- and the washer fluid hoses -3- with the connector on the plenum chamber cover.

-- Release the side catches, tilt the cap -4- upward -arrow-.

-- Press the washer fluid hoses -3- to the side slightly.

Courtesy of AUDI OF AMERICA, LLC

-- Shift the washer fluid hose to free it up.

-- Using a screwdriver, pry the cap -arrow- out of the windshield wiper arm -1-.

-- Remove the nut -2-.

-- Position the hook -2- on the windshield wiper arm -1-.

Courtesy of AUDI OF AMERICA, LLC

-- Position the Puller - Windshield Wiper: T40394 on the opposite side of the windshield wiper arm and latch the pivoting hook -3-.

-- Push the locking ring -4- downward in direction of -arrow-.

-- Turn the bolt -5- clockwise until the windshield wiper arm is removed from the windshield wiper axle.

-- Remove the windshield wiper arms.