INSTRUMENT CLUSTER WITH Instrument Cluster Control Module -J285-, REMOVING AND INSTALLING, INSTRUMENT CLUSTER HIGH, BEFORE PRODUCT IMPROVEMENT: Removing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ7, 2022 Audi Q7, 2021 Audi SQ7, 2021 Audi Q7, and 2020 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the driver side instrument panel vent. Refer to OVERVIEW - INSTRUMENT PANEL .

-- Remove the access/start authorization switch trim. Refer to ACCESS/START AUTHORIZATION SWITCH TRIM, REMOVING AND INSTALLING .

-- Remove the bolts -1 and 3-.

Courtesy of AUDI OF AMERICA, LLC

-- Guide both Hook Tools: T40207 between the instrument panel and instrument cluster and attach at the outer vent openings as shown.

-- Using both Hook Tools: T40207 , carefully remove the instrument cluster -2- from the retainer in direction of -arrow- and tilt toward the rear.

-- Disconnect the connectors:

Courtesy of AUDI OF AMERICA, LLC

For the fiber-optic cable
For the antenna
For the instrument cluster

-- Seal the open wiring harness connector -2- of the fiber-optic cable with the Fiber-Optic Repair Set - Connector Protective Caps: VAS6223/9 -1-.

Courtesy of AUDI OF AMERICA, LLC

TIP:

The protective cap prevents contamination of or mechanical damage to the front surface of the fiber-optic cable which would impair light transmission.

-- Remove the instrument cluster on the front passenger side between the steering wheel and the instrument panel.