Part II
WARNING: This page is about a different car, the 2022 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
Part I. Refer to Part I .
Part III. Refer to Part III .
- Nut
- 30 Nm
- After loosening, replace the stud bolt -item 4-
- Tensioning Bracket
- Seal
- Replace after removing
- Stud Bolt
- 15 Nm
- After loosening, replace the nut -item 15-
- Tensioning Bracket
- Nut
- 30 Nm
- After loosening, replace the stud bolt -item 4-
- Oil Return Line
- Replace after removing
- Clip
- Air Duct Pipe
- Bolt
- Tightening specification -item 9-.
- Seal
- Replace after removing
- Air Duct Pipe/Connections
- There are different versions. Refer to the Parts Information for the allocation.
- Bolt
- Tightening specification -item 12-.
- Seal
- Replace after removing
- Nut
- Replace after removing
- Tightening Specifications:
- Step 1: 15 Nm
- Step 2: 30 Nm
- Step 3: After finishing the procedures, tighten the nuts to 30 Nm
- Turbocharger
- Removing and Installing. Refer to TURBOCHARGER, REMOVING AND INSTALLING, 3.0L ENGINE .
- Screw-Type Clamp
- 20 Nm
- Replace after removing
- Seal
- Replace after removing
- Coupling
- If a new turbocharger is installed, replace the coupling
- Nut
- Replace after removing
- Tightening Specifications:
- Step 1: 15 Nm
- Step 2: 30 Nm
- Step 3: After finishing the procedures, tighten the nuts to 30 Nm
- Seal
- Replace after removing
- Stud Bolt
- 15 Nm
- After loosening, replace the nut -item 20-