After-Run Coolant Pump -V51-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2022 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .

-- Drain the coolant. Refer to COOLANT, DRAINING AND FILLING .

Audi Q7 Until Product Improvement without Auxiliary Heating:

Courtesy of AUDI OF AMERICA, LLC

-- Lift the clamp -1- and remove the coolant hose.

-- Open the retainer in direction of -arrow- and push the Coolant Recirculation Pump -V50- to the side.

-- Remove the nuts -arrows- and remove the bracket -1- for the Coolant Recirculation Pump -V50-.

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Ignore -2-.

Continuation for All Vehicles:

Courtesy of AUDI OF AMERICA, LLC

-- Remove the double bolts -2- and bolts -1- and remove the bracket for the After-Run Coolant Pump -V51-.

-- Release and disconnect the connector -3-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -arrow- using the Socket - T30: T10405 .

-- Loosen the hose clamp -1- and remove the After-Run Coolant Pump -V51- -2-.